Hanover DG3 - Page 42

DG3 Controller – Installation and Operation
Manual
540846-3 page 42 of 64 25/09/2015
The controller will show the message
‘Remove USB drive:’ and will flash and
beep continuously until the USB stick is
removed, whereupon the DG3 will reboot.
9
The DG3 starts rebooting and installing the
firmware.
10
After a firmware update, the database is
deleted and the controller will show ‘NO
DATA’.
To transfer the database from the USB stick
to the DG3, please refer to section 3.2.4
Load completed
Remove USB drive:
Loading…
|||||||||||||||||||||||||||||||||||
|||||||||
Please wait…
DERIC-G3 V1.12
abcdeNCP012U//
Factory settings loaded
HANOVER
Deric G3 Bootloader
Installation completed
|||||||||
Deric G3 Bootloader
Installing…
|||||||||||||||||||||||||||||||||||
|||||||||
Deric G3 Bootloader
Checking…
Vinc 03.68-001 (1.00R)
|||||||||
Deric G3 Bootloader
G3-BOOT V1.04
Vinc 03.68-001 (1.00R)
|||||||||
Rebooting…
Load completed
NO DATA
-- --  ----