Hanover DG3 - 5.4 Other information; 5.4.1 Replacing a DERIC+ controller with a DG3 controller; 5.4.2 Replacing an ERIC++ controller with a DG3 controller

DG3 Controller – Installation and Operation
Manual
540846-3 page 49 of 64 25/09/2015
5.4.1 Replacing a DERIC+ controller with a DG3
controller.
Can I change an ERIC++ for a DG3?
Yes, you will need Hanover adaptor cable CX330X or
CX330N and a USB flash drive. Please refer to
2.2.2.2 CX330X OR CX330N – For replacing an
ERIC++ controller and 5.4.2 Replacing an ERIC++
controller with a DG3 controller.
Do I need a new database for the DG3?
No, your existing database will work.
I have to use a Helen-compressed database,
will this work?
Yes.
My database uses profiles, will this work with
the DG3?
Yes, the DG3 supports profile and container file
databases.
Other information
Replacing a DERIC+ controller with a DG3 controller
No.
Description
Refer to section
1
The casing of the DG3 is of the same size to that of the DERIC+. So, the
actual position of the DERIC+ is appropriate for fitting a DG3 by direct
replacement.
2.1 Fitting the
controller
2
From the rear of the DERIC+ controller, unplug the 2-way
(communications) and 3-way (power) plugs
2.2.2 Adaptor cable
3
Loosen and unclip the screw fixings holding the DERIC+ controller in
place: it should then slide out of its mounting
4
The DG3 controller can be used with a conversion cable CX330K when
replacing a DERIC+. This has an 18-way minifit connector which plugs into
the rear of the DG3 and three connectors at the other end which can be
connected directly to the power and communications plugs previously
connected to the DERIC+
Replacing an ERIC++ controller with a DG3 controller
No.
Description
Refer to section
1
The casing of the DG3 is of different size to that of the ERIC++.
Consequently, the actual position of the ERIC++ is no longer appropriate
for fitting a DG3. If it is not possible to modify the size of the actual position,
look for another appropriate position for fitting the DG3 while making sure
the new wiring system is properly made.
2.1 Fitting the
controller
2
From the rear of the ERIC++ controller, unplug the 2-way
(communications) and 3-way (power) plugs
2.2.2 Adaptor cable
3
Loosen and unclip the screw fixings holding the ERIC++ controller in place:
it should then slide out of its mounting
4
The DG3 controller can be used with a conversion cable CX330X or
CX330N when replacing an ERIC++. This has an 18-way minifit connector
which plugs into the rear of the DG3 and three connectors at the other end