DG3 Controller – Installation and Operation Manual
540846-3 page 62 of 64 25/09/2015
1 = yes (and can be changed)
information code is visible or accessible on the controller, and
information is shown on the passenger signs
0 = The system behaves as with a normal
Helen-configured information message.
1 - 8 = The number of destination pages is
limited to this value. After they have all been
shown, the information message is shown.
X = The information page is shown after
every individual destination page.
Determines how the information pages are presented when IN / INI is activated –
please refer to section External inputs I0 and I1: emergency message, bus
reversing, bus stopping, battery guard, information message or Hanvox message.
A route number is first entered and then all destinations available for that route
can be scrolled and selected.
Note: the entries in the HELEN database must have 10 digit codes of the form
00RRRRDDDD where RRRR is the Route No to be entered and DDDD identifies
the destination within that route.
1 = yes (default is 1 for comms-enabled
versions)
Controls whether remote control function is enabled
Controls whether driver-configurable route numbers can be viewed and changed
on the controller.
Notes:
Pre-configured route codes cannot be altered directly via the controller
This feature has no effect if the controller is in route browse mode.
To Next Page
Loading...