Hanseatic HTW610D - Aligning the Appliance; Water Connection; Establish Drain for Water

Page EN-31
Installation, connection and initial commissioning
– The ground must be secure, even, clean
and dry.
– It is not appropriate to have a rug or car-
pet under the appliance, as the appliance
will not be ventilated well enough and can
overheat.
For use on rugs, carpets, parquet or wood-
en floorboards, place a stable wooden
board (measuring at least 40 × 60 cm) un-
derneath the appliance.
If it is placed on a wooden plate or base,
the screw-on feet should be fixed so that
the appliance does not dislodge itself when
spinning.
Lay a smooth tiled floor or rubber mat un-
der the screw-on feet.
Aligning the appliance
(30)
(20)
1. Loosen the lock nut (30) of one of the
screw-on feet (20) underneath the appli-
ance.
2. Using your hand, screw the foot (20) in
or out as far as necessary. To adjust the
foot, twist it
– anti-clockwise to unscrew.
– clockwise to screw in.
3. Repeat this for the other screw-on feet
until the appliance is standing completely
horizontally and securely.
4. Twist the lock nuts of all screw-on feet
upwards to the underside of the machine
and tighten the lock nut against the un-
derside of the machine.
Water connection
Establish drain for water
WARNING!
Risk of scalding!
Improper handling of the appliance
can lead to scalding caused by hot suds.
■ Fix the hose to the sink or bath to pre-
vent it from slipping due to the recoil
caused by pumping.
■ For drains, make sure that the
cross-section of the discharge pipe is
great enough that the drain cannot
overfl ow.
NOTICE
Risk of damage to property!
Improper handling of the appliance
can lead to water damage.
■ Use only the water outlet hose pro-
vided.
■ Do not extend the water outlet hose
or replace it with another hose.
■ The water outlet hose must not get
bent or twisted.
■ The curvature of the water outlet
hose must be at least between 60cm
and 100cm above the ground to en-
sure the water drain functions per-
fectly.
■ The water outlet hose must be in the
retaining clips on the back of the ap-
pliance so that the bend on the hose
always remains above the waterline
inside the appliance. The end of the
hose must not be submerged in the
pumped water.