Automatic control functions
Page EN-25
Automatic control functions
The following functions run automatically. You
cannot change them.
Foam detection
The electronic foam detection makes sure
that more water is added to the first rinse cy-
cle for certain amounts of foam.
Overflow protection system
This system prevents the water from leaking
out over the dispensing drawer. As soon as
a certain water level is exceeded, the outlet
pump will automatically switch on.
Dynamic quantity control
If your washing machine is only loaded up to
half of the maximum capacity, the water con-
sumption and cycle duration will reduce for
certain cycles. Adjust the detergent dosage
accordingly.
Imbalance correction system
This system protects your washing machine
in the event of an imbalance that is too large
when spinning starts. This can happen with
small loads or with large individual pieces of
laundry. The laundry is distributed again and
the spin speed increased if the laundry distri-
bution is right.
To Next Page
Loading...
Need help?
General