Hanseatic HWMB814B User Manual

Page EN-32 Set-up and connection
Creating a water drain
CAUTION!
Risk of scalding!
The suds can become very hot and may
cause burns upon contact.
■ Securely attach the water drain hose
to a drain or bath to prevent it from
slipping due to the recoil caused by
pumping.
■ For drains, make sure that the cross
section of the discharge pipe is great
enough that the drain cannot over-
fl ow.
NOTICE
Risk of damage!
Improper handling of the appliance
can lead to water damage.
■ Do not extend the water drain hose
or replace it with another hose.
■ Make sure that the water drain hose
is not kinked or twisted.
■ Make sure that the curvature of the
water drain hose is at least 60 cm
(max. 100 cm) above the ground to
ensure the water drainage functions
perfectly.
■ Ensure that the water drain hose is
in the retaining clips on the back of
the appliance so that the curvature
always remains above the waterline.
■ Make sure that the end of the hose is
not submerged in the pumped water.
The water drain hose (14) can be secured in
two ways:
– Fixing with a hose holder for self-installa-
tion.
– Fixing to an appliance connection nozzle
directly on the siphon by a specialist.
Fixing with a hose holder
• Put the end of the water drain hose (14)
over a hose holder (not included in pack-
Water connection diagram
~
95
cm ~ 14
0
cm
0
– max.
80
cm
~
95
cm ~ 1
50
cm

Hanseatic HWMB814B Specifications

General

Brand	Hanseatic
Model	HWMB814B
Category	Washer
Language	English