EasyManuals Logo

Hantek HDM3065 Series User Manual

Hantek HDM3065 Series
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
38
The continuous measurement method is as follows:
≤ 10 Ω
Display measured resistance and buzzer (if
buzzer is enabled.)
10 Ω to 1.2 k
Display measured resistance, no buzzing
> 1.2 k Ω
Display OPEN, no buzzing
The diode
This section describes how to configure diode tests on the front panel.
Step 1: Configure the test leads, as shown below.
Step 2: Press the one on the front panel to open a menu which specifies
whether the DMM will ring to indicate a successful diode test.
The diode measurement method is as follows:
0 to 4.9 V
The voltage is displayed on the front panel and the instrument beeps when the
signal is converted to a threshold of 0.3 to 0.8V. (if beeping is enabled.)
> 5 V
The front panel shows Open
Frequency and period

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hantek HDM3065 Series and is the answer not in the manual?

Hantek HDM3065 Series Specifications

General IconGeneral
BrandHantek
ModelHDM3065 Series
CategoryMultimeter
LanguageEnglish

Related product manuals