BX176 portable single gas detector operation manual
11
automatically, please contact to the seller.
Memmory error:
In this status the detector will try to restore the
error automatically, if restoration succeed, the
detector will go to calibrating mode, please set
the detector according to 4.7, if restoration fail,
the detector will power off automatically,
please contact to the seller.
Undervoltage:
Giving Sandhi alarm sound once per
minute.
This figure will disappear after voltage is
too much lower, then the detector can
work only for maximum 15minuts,
please charge it in time otherwise it will
power off automatically.
Note：① Vibration only can be available when the vibration item
setup is on.
②This function is only available in combustible gas detector.
If you want to turn off the alarm sound and alarm vibration under
continuous alarm status, press , and then the detector screen will
have two icons of and flashing.
4.6 Check the status
Under detecting mode, press and at the same time,screen
will automatically display the time, current concentration, STEL
value①, TWA value①, the biggest detecting concentration and the
To Next Page
Loading...