Safety information
Before using the detector, please carefully read the below safety
information first and follow the operate requirement:
1. Please don't use the defective detector. Before using, please check if
there is scratch on the detector or spare part missing.
2. Every day before using the detector, you’re suggested to follow 4.3
and do “impact test” to be make sure the detector works well.
3. “Impact test” is suggested to be done periodically to guarantee the
good performance of audible , visual and vibration alarm.
4. Accessories approved by the seller are only permitted to be used on
the detector.
5. Only use the charger which comes with the machine to charge the
detector in safe environment, charging in dangerous place is
absolutely prohibited.
6. Detectors using catalytic sensor or semi-conductor sensor cannot
exposure to gases which the concentration is over the detector’s
range, otherwise it will increase the detector’s load and interfere its
performance or even damage the detector.
7. Detectors using catalytic sensor or semi-conductor sensor cannot
exposure to gas environment which contain lead compounds, sulfur
compounds, phosphorous compounds or silicon, otherwise it will
poison the catalytic sensor or the semi-conductor sensor.
8. Detectors using catalytic sensor or semi-conductor sensor cannot
exposure to gas environment which contain hydrogen sulfide,
halogenated hydrocarbon or high corrosive environment, otherwise
it will restrain the sensor’s response, decrease the sensor’s
sensitivity. If you have to use the detector in above environment,
please do “impact test” after detection finish.
9. The detector cannot exposure to electric shock, strong
electromagnetic or severe continuous mechanical vibration
environment.
10. Do not put the used battery of this detector together with other
garbage.
11. Privately disassemble, adjust, or repair the detector is prohibited.
12. The detector should be protected from falling down from high
above or severe vibration.
13. Any application or using trouble beyond this manual, please contact
to the seller.
To Next Page
Loading...