Preparing the Camera
To remove the memory card, please push the card in again until it is
partly ejected.
Notice:
■ Please format the memory card if it is used for the first time or if it
has been used with other cameras before.
■ Don’t remove the card or turn off the power while formatting or
reading or saving the files from the memory card, this might lead to
data losses.
■ Suggest to use the micro SD card at least class 10 or higher.
■ Be sure the power switch is OFF before inserting or removing the
memory card or batteries.
■ If the memory card has been used for many times, its performance
might be reduced. If the memory card performance decreases, please
replace the old new memory card with the new one.
■ If the capacity of the memory card is full, the camera will stop
recording automatically and the LEDs will be off. Turn on the loop
recording function if you want to keep on saving data: in this case the
newest data will replace the oldest.
■ Do not insert the memory card forcibly. Please refer to the marking
on the camera. Press the edge of the card gently to pop up the TF card.
To Next Page
Loading...