EasyManua.ls Logo

HAPIMP SV-TCQ - Proper Camera Installation

HAPIMP SV-TCQ
142 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Basic Operation
15
The installation height is determined by the size of the shooting
target or the distance, such as a small hedgehog, the shooting distance
should be as short as possible, and the installation height should be as
low as possible).
There should be no obvious obstructions (such as branches and
leaves) in the front of the lens, and try to keep it as open as possible.
Try to confirm that there is no strong backlight at the front of the lens,
otherwise, the quality of the photos and videos taken will be seriously
reduced, and noise and blurring will occur.
3. Basic Operation
3.1. "ON","TEST" and "OFF" modes
3.1.1. When the camera is under the "TEST" mode
After you have placed the batteries and memory card in, under the
TEST mode, you can set parameters, check the camera, manually shoot
and view photos and videos, etc.
- -
+ +

Table of Contents