Preparing the Camera
the “TEST” position, then move slowly from one side of the target area
to the other side. While doing this, look at the left LED indicator.
If you see the left LED indicator light up, that means you have been
detected by the motion sensor and know the motion sensor is working
properly. In this way, you can work out the best alignment for the
camera.
To ensure that the camera does not make unwanted recordings of
irrelevant movements, it should not be set up in a sunny location or
close to branches that can move in the wind.
Please refer to the above installation diagram to determine the correct
installation angle, install the hunting camera as horizontally as possible,
and do not install it downwards, which will reduce the capture range of
the camera and the shooting angle.
Notice:
■ The left LED indicator is to test whether the motion sensor works
properly, so only when the switch is at the TEST position, when the
motion is detected, it will light up. It does not light up when the switch
slides to ON, so you don’t need to worry the camera will disturb the
animals.
■ The correct installation distance should be at least one meter away
from the object, otherwise, it is easy to be vague.
■ Please make sure to install the hunting camera horizontally,
otherwise, it may reduce the detection range of the camera.
To Next Page
Loading...