Harbor Freight Tools LuminarWORK 69286 - Lithium Battery Safety; Lithium Battery Warnings; Grounding Safety; Symbology

Page 3
For technical questions, please call 1-800-444-3353.
Item 69286
SAFETYOPERATIONMAINTENANCE SETUP
Lithium Battery Safety Warnings
LITHIUM BATTERIES STORE A
LARGE AMOUNT OF ENERG
Y
AND WILL VENT FIRE OR
EX
P
LODE IF
MISTREATED:
1.
Keep Battery
P
ack dry.
2.
DO NOT DO AN
Y
OF THE FOLLOWING
Y OF THE FOLLOWING Y
TO THE BATTER
Y P
TO THE BATTERY PTO THE BATTER
A
Y PAY P
C
K:
a.
Open,
b.
Drop,
c.
Short-circuit,
d.
P
uncture,
e.
Incinerate, or
f.
Expose to temperatures greater than
140°F.
3.
Charge Battery Pack only according
to its Adapter’s instructions.
4.
Inspect Battery Pack before every use;
do not use or charge if damaged.
SAVE THESE INSTRU
C
TIONS.
Grounding
TO
P
REVENT ELE
C
TRI
C
SHO
C
K AND DEATH
FROM IN
C
ORRE
C
T
GROUNDING WIRE
C
ONNE
C
TION:
C
heck with a qualified electrician if you are in doubt as to whether the outlet is properly
grounded. Do not modify the power cord plug provided with the Adapter. Do not use the Adapter
if the power cord or plug is damaged. If damaged, have it repaired by a service facility before use. If the
plug will not fit the outlet, have a proper outlet installed by a qualified
electrician.
Outlets for 2-
P
rong
P
lug
1.
Tools marked “Double Insulated” do not
require grounding. They have a special
double insulation system which satisfies
OSHA requirements and complies with
the applicable standards of Underwriters
Laboratories, Inc., the Canadian Standard
Association, and the National Electrical Code.
2.
Double insulated tools may be used in either of the
120 volt outlets shown in the preceding illustration.
(See Outlets for 2-
P
rong
P
lug.)
Extension
C
ords
Note:
Extension cords must not be used with this item’s Adapter.
Extension cords must not be used with this item’s Adapter.
Symbology
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
A
Amperes
WARNING marking concerning Risk
of Eye Injury. Wear
ANSI
-
approved
safety goggles with side shields.
Read the manual before
set-up and/or
use.
WARNING marking
concerning Risk of
Fire.
WARNING marking concerning
Risk of Electric Shock.
Properly connect Adapter’s power
cord to appropriate
outlet.
WARNING marking concerning
Risk of Explosion.
Do not puncture, short, or open
battery packs and do not charge
damaged battery packs.