2.1
2 - Safety notes
Operator safety
Symbols
These symbols are used throughout the book to designate where the reader needs to pay extra attention.
€
This symbol means DANGER. Be very alert as your safety is involved!
±
This symbol means WARNING. Be alert as your safety can be involved!
This symbol means ATTENTION. This guides to better, easier and safer operation of your sprayer!
÷
This symbol means NOTE.
General info
Before using the sprayer, read the following recommendations and safety instructions.
• Read and understand this instruction book before using the equipment. It is equally important that other operators of
this equipment read and understand this book.
• If any portion of this instruction book remains unclear after reading it, contact your HARDI® dealer for further
explanation before using the equipment.
• Local law may demand that the operator is certified to use spray equipment. Adhere to the law.
• Wear protective clothing. Wash and change clothes after spraying.
• Wash tools if they have become contaminated. Rinse and wash equipment after use and before servicing.
• Never service or repair the equipment while it is operating.
• Always replace all safety devices or shields immediately after servicing.
• Do not eat, drink or smoke while spraying or working with contaminated equipment.
• In case of poisoning, immediately seek medical advice. Remember to identify chemicals used.
• Keep children away from the equipment.
• Be careful not to hit people or surroundings when maneuvering the sprayer, especially when backing.
• Do not fold or unfold boom near overhead wires. Serious injury or death could result if contact is made with electric
wires.
• Slow down when driving in uneven terrain, as the machine might be in risk of turning over.
• Pressure test with clean water prior to filling with chemicals.
• Disconnect electrical power before servicing and depressurize equipment after use and before servicing.
• Do not go under any part of the sprayer unless it is secured. The boom is secure when placed in the transport brackets
with rear transport lock secured.
• If an arc welder is used on the equipment or anything connected to the equipment, disconnect power leads before
welding. Remove all flammable or explosive material from the area.
To Next Page
Loading...
Need help?
General
