Hardi ES 30 - Boom Operation and Controls; Spraygun Operation and Adjustment

11
HARDI
®
12 VOLT ESTATE SPRAYER OPERATOR’S MANUAL
Fig. 4
2. Fill the tank with clean water.
3. Turn dial A (Fig. 3) counter clockwise all the way out.
4. Set boom switch B (Fig. 3) on and spraygun switch C (Fig. 3) off.
5. Turn electrical switch D (Fig. 2) on to spray water from the boom.
6. Increase pressure by turning dial A (Fig. 3) clockwise. Watch the
pressure gauge E (Fig. 3) until the desired pressure is reached
(turning dial A (Fig. 3) counter clockwise decreases pressure).
7. When spraying with the boom, use the electrical switch D (Fig. 3)
to turn the boom on and off.
Spraygun Operation
8. To operate the spraygun, turn switch B (Fig. 3) off and switch C
(Fig. 3) on. Then depress the red handle F (Fig. 4) to spray water
from the spraygun. Check the pressure on gauge E (Fig. 3) and
follow step 6 to adjust.
9.
To adjust the spray pattern, turn the black handle G
(Fig. 4)
OUT for a narrow spray pattern for long
distances and IN for a wide pattern for more
coverage at close distances.
Fig. 3
ON
OFF
D