Hardlife Utility C2020 User Manual

7
www.hardlifeutility.com
6. Secure the lower and upper tracks using M10 x 90 mm bolts (component code 29) and the door side
splint (component code 36), as shown in Figure 2. Secure the upper tracks (11L and 11R) to the arch us-
ing M10 x 30 mm bolts (component codes 32), as shown in Figure 2.
7. Install the bottom tensioning tubes at the front panel (component code 14), as shown in Figure 1.
NOTE:
• Plug both the ends of the bottom tensioning tubes with plastic plugs, if available.
• ere are clips on the base plates to x the bottom tensioning tubes, as shown in Figure 3.
8. Install the horizontal tubes at the front panel (component code 13), as shown in Figure 1. Secure com-
ponent code 13 to component codes 9 / 9A using M8 x 70 mm carriage bolts (component code 30), as
shown in Figure 2. Secure component code 13 to the tracks using M10 x 30 mm bolts (component code
32).
9. Install the winch door beams (component code 12) between the winch door’s upper tracks, and secure
using M10 x 90 mm bolts (component code 29), as shown in Figure 2.
Figure 2

Hardlife Utility C2020 Specifications

General

Brand	Hardlife Utility
Model	C2020
Category	Shelters
Language	English