6-12 2005 PDI: VRSC Models
DEALER ROAD TEST 6.8
ROAD TEST
After you complete motorcycle inspection, take motorcycle for
a road test. Check all systems and overall operation of motor-
cycle: engine, transmission, clutch, brakes, handling, etc.
After road test, return motorcycle to shop, and thoroughly
clean off any road dirt. Check and correct any problems you
may have found during road test.
Before You Begin
Check the following items before road test of vehicle:
● Lamps and indicators.
● Check amount of gasoline in tank and add (if
needed).
● Adjust mirrors to proper riding positions.
● Check tire condition and pressure (adjust if neces-
sary).
● Check controls to verify proper function.
● Check all electrical equipment and switches includ-
ing stop lamp, turn signals and horn for proper oper-
ation.
Road Test of Vehicle: Low Speed
1. Shift from first through third gear, checking clutch opera-
tion, throttle control, and transmission operation.
2. Verify low speed braking for front and rear brakes.
3. Handling under braking conditions.
4. Low speed handling. Verify that vehicle does not pull to
left or right.
5. Check for any abnormal vibrations.
6. Check electrical lamps, indicators.
Road Test of Vehicle: Highway Speed
1. Shift from first through fifth gear, checking clutch opera-
tion, throttle control, and transmission operation.
2. Verify highway speed braking operation of front and rear
brakes.
3. Verify proper handling at highway speeds.
4. Check for any abnormal vibrations.
● Program Security System (if equipped)
● Engine Oil:
Check and correct hot level.
● Clean Vehicle
NOTE
Be sure to submit a Dealer Product Quality Audit (DPQA) on
ANY adjustments and/or warranty work performed required to
deliver the vehicle to the customer.
To Next Page
Loading...