19.10.1. Banjo boltCartridge body O-ring (2)Retaining ring
2. 20.11.Washer Brake lineCartridge body
12.3. 21.ReservoirBoot Jam nut
22.13.4. Brake rod (FXDWG)Cover gasketRetainer
5. 23.14.Spring Brake rod (all but FXDWG)Cover
15.6. 24.Screw (2)Retaining ring Brake pedal (all but FXDWG)
25.16.7. Brake pedal (FXDWG)Frame bracketRetaining ring
8. 17.Washer Nut
18.9. Banjo washer (2)Push rod
Figure 2-74. Rear Brake Master Cylinder
DISASSEMBLY
1. Clean exterior of master cylinder/reservoir with a clean,
nonflammable solvent. Lubricate all internal parts with
lubricant provided in kit.
2. See Figure 2-74.Thread banjo bolt (19) into the cartridge
body (11).
3. Remove boot (3) from groove in master cylinder/reservoir
(12). Set master cylinder/reservoir upright with banjo bolt
resting on bench and push master cylinder/reservoir down
and off the cartridge body.
4. Protect cartridge body from dirt or grease.
5. Press down on large washer (2) to compress spring (5),
keep spring compressed and remove retaining ring (1)
from groove in push rod (9).
6. Carefully release spring and remove washer, boot, spring
retainer (4) (inside boot) and spring.
2-42 2008 Dyna Service: Chassis
To Next Page