2.25HANDLEBARS: ALL BUT FXDWG/FXDF
REMOVAL
All Models
To prevent accidental vehicle start-up, which could cause
death or serious injury, disconnect negative (-) battery
cable before proceeding. (00048a)
1. Disconnect negative battery cable.
2. Place blanket or protective cover over front of fuel tank to
protect against scratches and other damage.
3. Remove front master cylinder assembly. See 2.12 FRONT
BRAKE MASTER CYLINDER.
4. Remove two screws securing clutch control assembly to
left side of handlebar. See 2.24 CLUTCH CONTROL.
5. Remove right and left handlebar switch assemblies and
throttle. See 8.29 RIGHT HANDLEBAR SWITCH or
8.30 LEFT HANDLEBAR SWITCH.
NOTE
Original equipment grip is glued in place and must be cut off
to remove. Remove grip only if necessary.
6. Remove left handlebar grip.
FXD/FXDC Models
1. See Figure 2-101. Remove speedometer cover fasteners
(5) and speedometer cover (4).
2. Remove upper handlebar clamp fasteners (1).
a. For FXD models, remove upper handlebar clamp and
speedometer assembly (2).
b. For FXDC models, remove upper handlebar clamp
(3).
3. Remove handlebar (6).
4. If removing lower handlebar clamps (7), remove two lower
handlebar clamp fasteners (13), lockwashers (12), ground
cable (15) and ground cable washer (14) and lower
handlebar clamps from upper fork bracket (11). Replace
bushings (9) if necessary.
1. Upper handlebar clamp fastener (4)
2. Upper handlebar clamp and speedometer
assembly (FXD)
3. Upper handlebar clamp (FXDC)
4. Speedometer cover (FXD)
5. Speedometer cover fastener (FXD, 2)
6. Handlebar
7. Lower handlebar clamp (2)
8. Cup washer (4)
9. Bushing (4)
10. Spacer (2)
11. Upper fork bracket
12. Lockwasher (2)
13. Lower handlebar clamp fastener (2)
14. Ground cable washer (right side only)
15. Ground cable (right side only)
Figure 2-101. Handlebars: FXD, FXDC
FXDB
1. See Figure 2-102. Remove handlebar clamp fasteners
(1).
2. Remove upper handlebar clamps (2).
3. Remove handlebar (3).
2008 Dyna Service: Chassis 2-69
To Next Page