Harley-Davidson Dyna 2008 - Page 141

2
1
3
4
5
sm03775
1. Upper handlebar clamp fastener (4)
2. Upper handlebar clamp (2)
3. Handlebar
4. Upper fork bracket
5. Ground cable (right side only)
Figure 2-102. Handlebars: FXDB
FXDL Models
1. See Figure 2-103. Remove riser cover fastener (6) and
riser cover (3).
2. Remove upper handlebar clamp fasteners (1).
3. Remove upper handlebar clamp (2).
4. Remove handlebar (4).
5. If removing risers (5), remove two riser fasteners (13),
lockwashers (12), ground cable (15) and ground cable
washer (14) and risers from upper fork bracket (11).
Replace bushings (9) if necessary.
1
6
5
2
3
8
9
10
11
9
8
12
13
14
15
4
7
sm02281
1. Upper handlebar clamp fastener (4)
2. Upper handlebar clamp
3. Riser cover
4. Handlebar
5. Riser (2)
6. Riser cover fastener
7. Riser cover retainer
8. Cup washer (4)
9. Bushing (4)
10. Spacer (2)
11. Upper fork bracket
12. Lockwasher (2)
13. Riser fastener (2)
14. Ground cable washer (right side only)
15. Ground cable (right side only)
Figure 2-103. Handlebars: FXDL
INSTALLATION
FXD/FXDC Models
1. See Figure 2-101. If lower handlebar clamps (7) were
removed, install lockwashers (12) on lower handlebar
clamp fasteners (13). Install ground cable (15) and ground
cable washer (14) on right-side fastener.
NOTE
In next step, make sure cup washers (8), bushings (9) and
spacers (10) are in position in upper fork bracket (11).
2. Slide lower handlebar clamp fasteners through upper fork
bracket.
3. Loosely install lower handlebar clamps to upper fork
bracket using lower handlebar clamp fasteners.
4. Place handlebars (4) on lower handlebar clamps. Install
upper handlebar clamp (2 or 3). Install but do not tighten
clamp fasteners.
2-70 2008 Dyna Service: Chassis