Harley-Davidson Dyna 2008 - Page 146

2.27FRONT FENDER
REMOVAL
1. See Figure 2-106. Remove both fender mounting screws
(2) and nuts (3) on each side.
2. Carefully remove fender being careful not to scratch the
fender paint.
INSTALLATION
1. Carefully position fender and align mounting holes.
2. See Figure 2-106. Ensure the fender mounting brackets
are resting against the machined bosses of the forks and
install screws (2) through fender mounting holes in fork
legs.Thread nuts (3) onto screws.
3. Tighten fender mounting nuts to 15-21 ft-lbs (20.3-28.5
Nm).
2
3
1
sm02283
1. Front fender
2. Screw (2)
3. Nut (2)
Figure 2-106. Front Fender
2008 Dyna Service: Chassis 2-75