Harley-Davidson Dyna 2008 - TOP END SERVICE 3.9; ENGINE IN CHASSIS

3.9TOP END SERVICE
ENGINE IN CHASSIS
Table 3-26. Engine In Chassis
COMPONENT REPAIR
PROCEDURE
SERVICE PROCEDURE
Remove parts to gain access to all components above cylinder deck. See
3.11 STRIPPING MOTORCYCLE FOR SERVICE.
Disassemble top end. See 3.15 TOP END OVERHAUL: DISASSEMBLY.
Inspect and repair.BREATHER ASSEMBLY
See 3.19 BREATHER ASSEMBLY*.
Inspect and repair.ROCKER ARM SUPPORT
See 3.20 ROCKER ARM SUPPORT PLATE*.
Inspect and repair.PUSH RODS, LIFTERS AND COVERS
See 3.21 PUSH RODS, LIFTERS AND
COVERS*.
Inspect and repair.CYLINDER HEAD
See 3.22 CYLINDER HEAD*.
Inspect and repair.CYLINDER
See 3.23 CYLINDER*.
Inspect and repair.PISTON
See 3.24 PISTON*.
Assemble top end. See 3.16 TOP END OVERHAUL: ASSEMBLY.
Assemble motorcycle. See 3.12 ASSEMBLING MOTORCYCLE AFTER SER-
VICE.
Note: * If no other work is to be done, you may advance to 3.16 TOP END OVERHAUL: ASSEMBLY when this step is completed
during top end service.
2008 Dyna Service: Engine 3-17