Harley-Davidson Dyna 2008 - Page 253

sm03855
Figure 3-141.Thread Pilot Adapter into Sprocket Shaft
1
2
3
4
5
6
7
8
9
sm03856
1. Pilot adapter
2. Pilot shaft
3. Handle
4. Flat washer
5. Nice bearing
6. Short collar
7. Long collar
8. Inner race
9. Thrust washer
Figure 3-142. Press Inner Race onto Sprocket Shaft: Setup
sm03857
Figure 3-143. Press Inner Race onto Sprocket Shaft:
Operation
CYLINDER STUDS
Removal
1. Thread a 3/8"-16 nut onto cylinder stud.
2. Thread a second nut onto stud until it contacts the first.
3. Placing wrench on first nut installed, remove stud.
Installation
1. Place a steel ball inside a head screw. Put the head screw
on the end of the cylinder stud without the collar.
2. Start the stud in the cylinder deck with the collar side down.
Tighten using air gun until collar reaches crankcase.
3. Hand tighten stud to 10-20 ft-lbs (3.6-27.1 Nm).
3-96 2008 Dyna Service: Engine