Harley-Davidson Dyna 2008 - Page 362

10. Install main drive gear. See 6.6 TRANSMISSION
SPROCKET.
11. Install the bearing inner race on the transmission main-
shaft. See 7.5 TRANSMISSION ASSEMBLY, Assembly.
12. Install the starter. See 5.2 STARTER, Installation.
13. Install the primary chaincase housing. See 6.4 PRIMARY
CHAINCASE HOUSING, Installation.
14. Install the clutch assembly, primary chain, chain tensioner
assembly and compensating sprocket components See
6.3 DRIVE COMPONENTS, Installation.
15. Install the primary chaincase cover. See 6.2 PRIMARY
CHAINCASE COVER, Installation.
sm03060
Figure 7-50. Place Installer (Part No. HD-47856-1) over
Adapter
sm03061
Figure 7-51. Install Nut (Part No. HD-47856-6)
1
3
2
sm03062
1. Crow's foot wrench
2. 1/2 inch breaker bar
3. Adjustable wrench
Figure 7-52. Press Seal Into Crankcase
2008 Dyna Service: Transmission 7-25