8.2ELECTRICAL CADDY
REMOVAL
NOTE
Security siren connector [142] is located under seat.
1. Remove seat.
To prevent accidental vehicle start-up, which could cause
death or serious injury, disconnect negative (-) battery
cable before proceeding. (00048a)
2. Disconnect negative battery cable.
3. See Figure 8-1. Firmly grasp both sides of electrical caddy
cover and pull outward to remove.
4. See Figure 8-2. Remove relay and fuse panels from
electrical caddy.
a. Insert small screwdriver into slot located under each
relay/fuse panel.
b. Using screwdriver, disengage relay/fuse panel from
electrical caddy.
c. Repeat for other relay/fuse panel.
5. See Figure 8-3. Disconnect main fuse connector from
electrical caddy (1).
a. Remove main fuse from connector.
b. Insert small screwdrivers into slots (4) located on each
side of main fuse.
c. Using screwdrivers depress tabs of main fuse con-
nector to disengage from electrical caddy.
6. Depress tab located on electrical caddy securing
TSM/TSSM/HFSM. Pull TSM/TSSM/HFSM from electrical
caddy. Disconnect TSM/TSSM/HFSM connector (2) [30].
7. Slide data link connector (3) [91] towards front of vehicle
to disengage from electrical caddy.
1. Electrical caddy
2. TSM/TSSM/HFSM connector [30]
3. Data link connector
4. Main fuse removal slots
Figure 8-3. Electrical Caddy Removal
8. See Figure 8-4. Disconnect electronic control module
(ECM) connector (2) [78].
9. Disconnect ignition coil connector [83].
10. Disconnect spark plug cables from coil.
11. Remove front electrical caddy fastener (4).
12. Remove top electrical caddy fasteners (3).
13. Remove wiring from electrical caddy.
14. Remove fasteners securing ECM and ground wire to
electrical caddy.
INSTALLATION
1. Attach ECM and ground wire to electrical caddy.
2. Install main fuse connector into rear of electrical caddy.
3. Install relay and fuse panels into rear of electrical caddy.
4. Route ECM and data link connector wiring through rear
of electrical caddy past ECM.
8-2 2008 Dyna Service: Electrical
To Next Page