5. See Figure 8-5. Route TSM/TSSM/HFSM wiring through
rear of electrical caddy as shown.
6. See Figure 8-4. Install but do not tighten electrical caddy
front fastener (4).
7. Install electrical caddy top fasteners (3).Tighten to 90-110
in-lbs (10.2-12.4 Nm).
8. Tighten electrical caddy front fastener to 40-60 in-lbs (4.5-
6.8 Nm).
9. Connect electronic control module (ECM) connector [78].
10. See Figure 8-3. Connect TSM/TSSM/HFSM connector (2)
[30] to TSM/TSSM/HFSM. Slide TSM/TSSM/HFSM into
electrical caddy until tab of caddy engages
TSM/TSSM/HFSM.
11. Install data link connector (3) to electrical caddy as shown.
12. Install main fuse.
13. Attach coil connector [83].
14. Attach spark plug cables. Rear cable is installed on upper
coil tower.
15. Install electrical caddy cover.
16. Connect negative battery cable.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
17. Install seat.
1. Electrical caddy
2. ECM connector [78]
3. Top electrical caddy fasteners (2)
4. Front electrical caddy fastener
Figure 8-4. Electrical Caddy Fasteners
To Next Page