8.3ELECTRONIC CONTROL MODULE (ECM)
GENERAL
The electronic control module (ECM) is mounted in the elec-
trical caddy. Refer to the Electrical Diagnostic Manual for
information on the function and testing of the electronic control
module.
NOTE
The electronic control module cannot be repaired. Replace the
unit if it fails.
REPLACEMENT
1. Follow removal instructions under 8.2 ELECTRICAL
CADDY to remove the electronic control module.
NOTE
After installing ECM, the password learning procedure must
be performed. See the Electrical Diagnostic Manual for this
model.
2. Follow installation instructions under 8.2 ELECTRICAL
CADDY to install the electronic control module.
To Next Page