8. See Figure 8-13. Using IGNITION SWITCH/FORK LOCK
WRENCH (Part No. HD-47853), turn face nut counter-
clockwise until tight.
9. See Figure 8-12. Install decal (6).
10. Remove and save key code tag (on key ring with two
keys). Key code is not marked on keys.
11. Push wiring harness into frame. Install harness shield by
installing tab of shield into frame first then engaging tabs
in holes in frame.
12. Place fuel tank into position and tighten hardware. Connect
fuel line. See 4.5 FUEL TANK.
13. Install console wiring.
14. Install instrument console.
a. For FXDWG, FXDC, FXDF models, see
8.17 INSTRUMENTS: FXDWG/FXDC/FXDF.
b. For FXDL, FXDB models, see 8.18 INSTRUMENTS:
FXDL/FXDB.
c. For FXD models, see 8.15 FUEL GAUGE.
15. Connect negative battery cable.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
16. Install seat.
17. Refer to Table 8-4.Test vehicle and fork lock operation.
1. Fork lock cavity
2. Slot
Figure 8-15. Fork Lock/Ignition Switch Cavity
Table 8-4. Key Switch Functions and Positions: 2008 Dyna Models
FUNCTIONSWITCH
POSITION
LOCATION AND OPERATIONMODEL
Ignition, lamps and accessories are off.OFFOn the right front of the motorcycle on the
steering head.
FXD, FXDL,
FXDB
Accessories and hazard warning flasher can be
turned on. Instrument lamps are on. Brake lamp
and horn can be activated. Key may be removed
except on international models.
ACC*
To unlock the switch and the front fork, push
the key in and turn it counterclockwise.
HDI: Press the lever/key (international) in and
turn it clockwise to the OFF position. Be sure
to push key in to move key to either position.
Ignition, lamps and accessories are on.IGNITION*
Fork Lock: To lock the fork, move the fork to
the full left position. Push down on key and turn
it to the right, clockwise, to the closed lock icon.
Remove the key.
Ignition, lamps and accessories are off.OFFSwitch is on fuel tank instrument panel.FXDWG,
FXDC, FXDF FXDWG/FXDF switch is locked or unlocked by
lifting switch cover, inserting key and turning
key counterclockwise to lock or clockwise to
unlock. Key may be removed in any position.
Accessories are on. Hazard warning flashers
can be operated. Instrument lamps are on.
Brake lamp and horn can be activated.
ACC*
Ignition, lamps and accessories are on.IGNITION*
Fork Lock: The fork lock is on the right front of
the motorcycle on the steering head. Insert key
and press to turn the lock to the closed lock
icon. Remove the key.
To unlock the fork lock, insert key and press to
turn the lock to the open lock icon. Remove the
key.
*International models have an additional function - position lamp and tail lamp are also on.
8-10 2008 Dyna Service: Electrical
To Next Page