Harman Kardon AVI 250 - Rear Panel Audio & Systems Connections

ENGLISH
Rear Panel Audio and System Connections
@ Tuner: Connect the output of an
AM/FM tuner to these jacks.
@® CD: Connect these jacks to the
output of a compact disc player or
CD changer.
@ Tape 1 In: Connect these jacks to
the PLAY/OUT jacks of an audio
recorder.
@® Tape 1 Out: Connect these jacks
to the RECORD/INPUT jacks of an
audio recorder.
@ Tape 2 In: Connect these jacks to
the PLAY/OUT jacks of a second
audio recorder.
@ Tape 2 Out: Connect these jacks
to the RECORD/INPUT jacks of a
second audio recorder.
© Main Amp In: These jacks con-
nect the output of an external pre-
amp to the unit's power amplifier. In
most normal use they are connected
via jumpers to the AVI250’s Pre-
Outs @.
@ Pre-Outs: If external power
amplifiers are used for any channels,
remove the connection pin and con-
nect the jack to the input of the
amplifier.
@ Subwoofer Pre-Out: Connect
this jack to the line level input of a
powered subwoofer. If an external
subwoofer amplifier is used, connect
this jack to the subwoofer amplifier
input.
@ 6-Channel Direct Inputs: If an
external digital audio decoder is
used for 5.1 (Dolby AC-3) audio,
connect the outputs of that decoder
to these terminals.
6
@ Front L Speaker: Connect these
terminals to the front left speaker.
@ Front R Speaker: Connect these
terminals to the front right speaker.
@ Surround L Speaker: Connect
these terminals to the left surround
speaker.
@ Surround R Speaker: Connect
these terminals to the right surround
speaker.
@ Center Speaker: Connect these
terminals to the center speaker.
@ Multi Room Interface: For multi-
room installations where keypad
remotes are in use, connect the key-
pad interface to this jack.
® Multi IR: Connect the output of
an IR sensor in a remote room to this
jack to operate the multi-room con-
trol system.
@ Multi-Out: When using the AVI
250 for multi-room audio, connect
this jack to the input of the audio
amplifier powering the remote room
speakers.
© Power Cable: Connect the AC
plug to a non-switched AC wall
output.
@ Switched AC Outlet: This outlet
may be used to power any device
that you wish to have on when the
unit is turned on.
@ Unswitched AC Outlet: This out-
let may be used to power any AC
device. The power will remain on at
this outlet regardless of whether the
AV1250 is on or off.
NOTE: The power consumption of
the device plugged into each of
these outlets should not exceed 120
watts.
@ Remote IR In: If the AVI250's
front panel IR sensor is blocked due
to cabinet doors or other obstruc-
tions, an external IR sensor may be
used. Connect the output of the sen-
sor to this jack.
@) Remote IR Out: This connection
permits the IR sensor in the receiver
to serve other remote controlled
devices. Connect this jack to the “IR
IN” jack on Harman Kardon or other
compatible equipment.