Harman Kardon AVI 250 - Multiroom Operation; Multi Room Selector Menu; Multiroom Volume Control Configuration

SELECT @. The video screen
will move to the MULTI ROOM
SELECTOR menu (Figure #17),
2. Press the > button @ until the
desired input source for the multi room
system is selected.
3. When the source is selected, press the
© button until the > cursor is next to
RETURN TO MAIN MENU. Press
SELECT.
4. Atthe MAIN MENU, press the wW
button once so that the > cursor is point-
ing to SET UP MENU. Press SELECT.
5. This will bring SET UP MENU 1
(Figure #2) to the screen. Press the W
button twice until the > cursor is point-
ingtoGO TO SET UP MENU 2.
Press SELECT.
6. When SET UP MENU 2 (Figure
#3) appears, the > cursor will be point-
ingtoMULTI RM VOL. Use the q
or > buttons €¥% on the remote to select
one of the following choices.
a. If the remote room is equipped
with a remote receiver only, volume
control will be performed by the
AVJ250 using a remote control in
the second room. For this type of con-
trol, select the VARIABLE option.
b. If the volume control in the remote
room will be controlled by the ampli-
fier in the remote room, or if a spe-
cialized amplifier such as the
AudioAccess AVX-603 will be used,
select FIXED.
Multiroom Operation
29
7. After making a selection, press the W
button once so that the > cursor is next
to SET LEVEL.
8. Use the <q or > buttons @ on the
remote to establish a volume level for
turn on or constant level, as determined
by the previous selection.
a. If VARIABLE volume has been
selected, this setting will determine
the volume level for the remote room
each time it is turned on.
b. If FIXED volume has been select-
ed, this level will be the constant vol-
ume level at the remote room
location unless a local volume con-
trol is installed. Set the level as close
to “0 dB” as possible without distort-
ing the output signal.
9, When the level has been entered, press
the ‘W button so that the > cursor is
pointing toRETURN TO MAIN
MENU and press SELECT.
10. Atthe MAIN MENU, use the navi-
gational arrow buttons on the remote to
exit from the main system.
The AVJ250 is now configured for multi
room operation.
Operation
Multi room operation is simple, and it
may be controlled from either the main
listening room where the AVI250 is locat-
ed, or from a remote room where an IR
receiver or Harman Kardon or Audio
Access keypad has been installed.
Main Room Operation
In this option, the remote room feed is
controlled from the main listening room
using the AVI250’s front panel controls.
HSINSNA
MULTI
ROOM SELECTOR
RETURN TO MAIN MENU
Figure 17
TURN MULTI-ZONE OFF?
USERS MAY BE
IN OTHER
LISTENING
ROOMS
PRESS
OR "CLEAR™ TO
AGAIN TO PROCEED
CANCEL
Figure 18