AVR
42
Advanced Remote Control Programming
If the message indicates that an update is available, press the front-panel OK button 4.
to begin the update.
During the update a progress bar and status messages will appear on the Message 5.
Display. Do not touch any controls on the AVR and do not interrupt the network
connection during the update.
When the update is completed the AVR will automatically power off, and after five 6.
seconds will automatically power back on. Once the AVR turns back on it’s ready to
use.
Resetting the Remote
To reset the remote to its factory default condition, simultaneously press and hold the TV
Source Selector button and the “0” Number button. When the TV Source button relights,
enter the code “333.” When the TV button goes out, and all of the Source Selector buttons
flash, the remote control will be reset.
Processor Reset
If the AVR behaves erratically after a power surge, first turn off the rear-panel Main
Power switch and unplug the AC power cord for at least 3 minutes. Plug the cord back
in and turn the receiver on. If this procedure doesn’t help, reset the AVR’s processor as
described below.
NOTE: A processor reset erases all user configurations, including video resolution,
speaker and level settings, and tuner presets. After a reset, reenter all of these settings
from your notes in the Appendix worksheets.
To reset the AVR’s processor:
Press the front-panel Standby/On switch to place the unit in the Standby mode (the 1.
Power Indicator will turn amber).
Press and hold the front-panel OK button for at least 5 seconds until the RESET 2.
message appears on the front-panel Message Display.
NOTE: After performing a processor reset, wait at least 1 minute before pressing any
Source Selector buttons.
If the receiver does not function correctly after a processor reset, contact an authorized
Harman Kardon service center for assistance. Authorized service centers may be located
by visiting our Web site at www.harmankardon.com.
0295CSK - HK (x65Series) AVR3650_365_2650_265 CORE OM, WORK18 danny.indd 42 01/07/11 11:34:11
To Next Page
Loading...
Need help?
General
