AVR 325/525/7200: RS-232 Port Instructions
Version 1.1 - Revised 6-Jan-2003
Page 5 of 5
USING THE CODE TABLE
The code table that accompanies this document contains both the IR codes that may be
used to program IR based systems as well as the binary and hex commands used to
program an RS-232 system.
The far left column shows the actual name of the button as it appears on the remote
control. The column next to it is the actual command for that button.
The “RS-232 Command” column are the full hexadecimal codes used for RS-232
programming or for use in programming IR based systems.
To Next Page
Loading...
Need help?
General
