(See page 46 for more information on reassigning the
surround back speakers for multiroom use.)
T
he letters inside each box display the active input
channels. For standard analog sources, only the L and R
will light, indicating a stereo input. For a digital source,
the indicators will light to display the channels being
r
eceived at the digital input. When the letters flash, the
digital input has been interrupted. (See page 39 for
more information on the Channel Indicators.)
Ù U
pper Display Line:
D
epending on the unit’s sta-
tus, a variety of messages will appear here. In normal
operation, this line will show current input source and
which analog or digital input is in use. When the tuner is
the input, this line will identify the station as AM or FM
and show the frequency and preset number, if any.
ı Lower Display Line: Depending on the unit’s sta-
tus, a variety of messages will appear here. In normal
operation, the current surround mode will show here.
ˆ Surround Mode Indicators: The current selected
surround mode will appear as one of these indicators.
Note that when the unit is turned on, the entire list of
available modes will light briefly, and then revert to
normal operation with only the active mode indicator
illuminated.
NOTE: When the Dolby Virtual Speaker mode is in
use, no
Surround Mode Indicator R will light.
However, the surround mode name will scroll in the
Lower Display Line Q.
˜ Remote Sensor Window: The sensor behind
this window receives infrared signals from the remote
control. Aim the remote at this area and do not block
or cover it.
FRONT-PANEL CONTROLS 77
FRONT-PANEL CONTROLS
AVR 340 OM 3/22/06 9:09 AM Page 7
To Next Page
Loading...
Need help?
General
