Harman Kardon AVR20 II

TUNER SECTION
- Press the FM/AM SELECTOR on
the front panel.
- Three different ways can be selected
for tuning.
A. SEARCH TUNING
lf signals are strong and there is no
interference, quick auto search tuning
is possible.
1. Press the SEARCH selector so that
the indicator, ‘SEARCH’ lights up.
2. Press the TUNING button (DOWN
or UP) to tune. Tuning will start
automatically and stop at a broadcast
station frequency with sufficient signal
strength.
3. If the station where tuning stops is
not the one you want, press the
TUNING button once again.
B. MANUAL TUNING
Auto tuning may be impossible if the
station signal is weak. If so, use
manual searching.
1. Press the SEARCH selector so that
the indicator ‘SEARCH’ goes off.
Operation
rapidly if the TUNING button is kept
pressed. Release it slightly before
reaching the desired frequency, and
press it intermittently until the desired
frequency is reached.
C. PRESET TUNING
STATIONS
PRESET buttons can be used to select
any desired station which has been
preset. To pre-set a station in memory:
1. Tune to the station to be memorized.
2. Press the MEMORY button and
_ press the desired preset station button
while the memory indicator blinks
(it will blink for about 4 seconds).
To recall the preset station, press the
desired STATION PRESET buttons.
If pressing only one number. There will
be a 4 second delay until the preset
is recalled
AMPLIFIER SECTION
1. Set the VOLUME CONTROL to the
extreme counterclockwise position.
. Turn the power on.
. Select the desired input function.
. Play the input source.
ae RECORDING
. Insert a blank tape in a cassette deck
(TAPE1 or TAPE2).
2. Select the desired input function.
3. Set the cassette deck to recording
mode. |
4. Play the input source. Recording
will start.
Lies DUBBING
. Insert a blank tape in cassette deck 2
TAPE2).
2. Insert a recorded tape in cassette
deck 1 (TAPE1).
3. Select the input function of TAPE2
MON to monitor the sound (see #10
on page 8).
4. Set cassette deck 2 to recording
mode.
5. Set cassette deck 1 to playback
mode. Dubbing will start. NOTE: If
you press the TEST TONE button
during TAPE RECORDING or TAPE
DUBBING, the audio signal is not
recorded.
PROTECTION CIRCUITS
This receiver has special protection
circuits.
MM The thermal overload protection
circuit automatically turns off the
power if it begins to overheat.
MM The overdrive protection circuit
automatically turns off the power
if it is about to deliver too much
power.
Mi The short protection circuit
automatically turns off the power
if the speaker terminals are
shorted.
If the receiver shuts off, check to be
sure that the ventilation holes on the
top of the receiver are clear of
obstructions, and check the speaker
connections and impedance.
ob ® NY
. Turn the VOLUME clockwise until
you reach the desired sound level.
2. Press the TUNING button (DOWN or
UP) to tune. The frequency will change
15