9
BDS 270/BDS 570
ENglIsh
Configure the Receiver, Select the Audio Source
and Using the Receiver
6. Press the right Cursor button to select EzSet/EQ, then use the cursor buttons to select
the configuration of your speaker system.
The EzSet/EQ automatic setup can calibrate the BDS system and configure the
loudspeakers parameters automatically to get the best sound performance.
Tone Controls
Audio Output
Speaker Settings
EzSet/EQ
Manual Configuration
Off
2.0
2.1
3.1
5.1
Audio Settings
7. Press the OK button, then press it again to select Continue in the EzSet/EQ (Automatic
Setup) box that appears.
The EzSet/EQ automatic setup can calibrate the BDS system and configure the
loudspeakers parameters automatically to get the best sound performance.
Tone Controls
Audio Output
Speaker Settings
EzSet/EQ
Manual Configuration
Off
2.0
2.1
3.1
5.1
Audio Settings
EzSet/EQ(Automatic Setup)
Please plug the microphone into the system and
then place it at ear level at your desired listening
position. If a Subwoofer is connected, set the level
control (on the Sub) to half.
Continue Cancel
8. Remain silent while the test noise plays through the speakers. As the test noise
circulates among the speakers the screen will show which speaker is being tested.
Left
EzSet/EQ(Automatic Setup)
Testing...
Please keep room silent.
SUB
L
LS RS
R
C
Audio Settings
9. When the testing process is completed, the “Testing...” message on the screen will
change to “All test done!”
10. Press the Clear/Exit button to exit the EzSet/EQ test procedure.
NOTE: If the test fails, the “Testing...” message on the screen will change to “Test failed,
please make sure the speaker is connected correctly and room is silent, then retest.”
Press the Clear/Exit button, make sure all speakers are correctly connected and perform
the test again from Step 6. Make sure that the room remains silent during the test.
Using the Receiver
Press the remote’s Home button to display the Home Menu screen:
1 / 5Exit Option
Type: Settings
Home Menu
Blu-ray Disc
FM Radio
HDMI input
Component input
Playlist
Settings
OPTIONS
HOME
The available sources are listed on the left. If a disc has been inserted into the receiver’s
built-in disc slot, it will appear on the list as “Blu-ray Disc,” “DVD Video”, “CDDA”
or “Data Disc” (audio or data CD-R disc). If you have inserted a USB device into the
receiver’s USB port, it will appear on the list as “USB.”
NOTE: Digital and analog audio sources connected to the receiver’s rear-panel digital and
line inputs will not appear on the list but can be selected using the remote’s “Aux” Source
Selector button (see below).
To select a source from the list, use the Cursor Up/Down buttons to highlight the desired
source, then press the OK button to select it.
You can also select a source directly by pressing its Source Selector button on the remote.
Source Selector
Buttons
DISC
AUX
RADIO
HDMI1
COMPONENT
HDMI3
HDMI2
2
EJECT POWER TV
1
3
5
4
6
8
0
7
9
REPEAT
HOME
DISPLAY
OPTIONS
SURROUND
OK
TOP MENU
POP-UP
CLEAR/EXIT
––
VOLUME
CHANNEL
MUTE
THUMBNAIL
ZOOM
BOOKMARK
PROGRAM
For complete information about using all of your BDS system’s features, you can
download the
BDS Blu-ray Disc
™
Receiver Owner’s Manual
from www.
harmankardon.com.
To Next Page
Loading...
