Front Panel Display
4
Installation & Operation
Installation
Connecting the DC520 to your audio
system is simple. Using standard RCA to
RCA audio interconnect cords, connect the
left and right
OUTPUT jacks on the rear
panel to the
TAPE INPUT jacks of your
receiver or preamplifier. Connect the
INPUT jacks on the DC520 to the TAPE
OUTPUT
jacks of your receiver or
pre-amp.
Connect the power to a non-switched AC
wall output, or to the accessory outlet on
the rear of another audio device in your
system and you are ready to go!
NOTE: When using the accessory outlet on
another product to power the DC520 make
certain that it has the ability to power a
device that draws at least 14 watts of
current in addition to the requirements of
other devices that may be plugged into the
accessory outlets. If you use a “switched”
outlet it is important to remember that the
host product must be turned on in order
for the DC520 to operate.
Single Deck Playback
The DC520 may be used as a conventional
auto reverse audio cassette deck, playing
back tapes from either transport.
1. Check the tape for excessive slack before
use. If necessary, take up the slack by
inserting a pencil into one of the cassette
hubs and rotate the pencil to take up the
slack.
2. Press the
EJECT Ld button for the
transport you wish to use.
3. Insert the tape with the open edge
facing down.
4. Gently press the door of the cassette
compartment
BK closed.
5. Select the appropriate type of Dolby
Noise Reduction, if any, using the
DOLBY
NR
switch b. This information is
typically displayed on the label of
prerecorded cassettes.
6. If you wish to clear the counter before
playback, press the
RESET button next to
the transport you will be using
DH.
7. Press the
PLAY/5 or6 button for the
transport that will be used. Play can be in
either the forward direction
OY, which
will play that side of the tape facing
outside of the door (may be “A” or “B”
corresponding to the labeling on the
cassette), or reverse
PZ to play the
opposite side of the tape. In any case the
tape will run into the direction in which
the arrow of the pressed
PLAY button
shows.
8. When the unit is in the play mode, tape
movement may be momentarily stopped
using the
PAUSE button R. Press the
Pause button again to resume operation.
1 Peak Level Meter – Segments
of this dual horizontal bar will illuminate
to indicate the input level for recording
or the output level on playback. The
meter will “hold” the average constant
level and flash and hold to indicate
momentary peaks.
2 Secondary Transport –
Directional Indicators: These indicators
display the movement of the
secondary tape transport.
3 Secondary Transport Counter
– This four digit display provides a
relative indication of
the tape position of the secondary
transport.
4 Sync Rev – This indicator lights
when the unit is programmed so that
both decks reverse at the same time
during dubbing.
5 Secondary Transport Play –
The indicator lights when the
secondary transport is in the Play
mode.
6 High Dub – This indicator lights
when the unit is in the high speed
(twice normal time) dub mode.
7 Norm Dub – These indicators light
during a dub recording to display the
tape speed.
8 Rec – This indicator lights when a
dub or recording is in progress.
9 Primary Transport Play – This
indicator lights when the primary
transport is in a playback mode. When
it lights in tandem with the REC
indicator 8, a recording or dub is in
process.
) Primary Transport Counter –
This four digit display provides a
relative indication of the tape position
of the Primary transport.
! Primary Transport
Directional Indicators – These
indicators display the movement of the
Primary tape transport.
To Next Page
Loading...
