Harman Kardon DC5300 - Basic Recording and Copying; Managing Recording Sessions; Cassette Copying Techniques

8. To pause recording, press
REC/PAUSE. To start recording
forward again, press p> (Forward Play)
again. To change record direction and
stay in the Pause mode, press <q
(Reverse Play).
9. To stop recording, press Ml.
10. You may also stop recording by
pressing the Rec Mute button. This
records four seconds of silence and
then returns the deck to the Record
Pause mode for recording additional
selections.
NOTE: In Auto Reverse mode, recording
direction is automatically reversed when
leader tape is detected. Press the Direction
Mode button until the display shows (2) ).
Auto Reverse will record both sides of the
tape and stop.
When in normal, one-way play mode,
indicated by = , the transport shuts off
when the tape reaches the end of the side.
Copying a Tape
The Copy function automatically copies the
full contents of one tape onto another with
the push of a single button.
1. Place the recorded tape in the
Secondary Transport and the blank
tape in the Primary Transport.
2. Select the correct type of Dolby Noise
Reduction. For the DC5700 only, the
NR type for the Primary Transport
must be set independently from the
Secondary Transport. Use the Pri/Sec
Transport selector button to enable
independent settings.
3. Press the Copy button. Copy blinks in
the Display, the Secondary Transport
automatically becomes current, and
both tapes are rewound to their
beginning. At high speed, both tapes
are then brought to the end of their
leaders. The Primary Transport goes
into the Record Pause mode and the
Secondary Transport goes into the
Play Pause mode. When both
Transports are ready, Copy mode
begins, indicated by a steadily
illuminated Copy in the display.
4. Tostop Copy mode, press Mf. The
Primary Transport automatically
becomes current, and the status of the
Secondary Transport is kept in
memory until power is turned off.
NOTE: The unit will automatically copy
both sides of a tape in this manner if the
direction mode indicator displays
(2) ) when Copy is pressed. If the
direction mode indicator displays z= , Copy
is automatically turned off when either tape
reaches its end.
Hi Speed Copy
The Hi Speed Copy function copies a tape
at twice normal speed with exceptionally
good sonic quality.
Follow the instructions for Copy mode;
however, after placing the recorded and
blank tapes in their appropriate transports,
press Hi Speed Copy.