Harman Kardon DC5300 - Installation and Connectivity; Packaging and Initial Placement; Connecting to Stereo Components; External Signal Processor Integration

Packaging
Save all packing material. It is essential for
shipping, should you move or in the event
the unit ever needs repair.
Placement
The unit may be placed on top or beneath
other stereo components, so long as its
placement meets the cooling requirements
of the component beneath it.
Ae ee
Make sure all stereo components are
turned off.
2. Use the cable provided to connect the
left and right Input jacks of the
cassette deck to the “Tape Monitor
Output” jacks (sometimes labeled
“Record”) of your pre-amplifier,
integrated amplifier, or receiver.
3. Connect the left and right Output jacks
on the deck to the “Tape Input” jacks
(sometimes labeled “Play” or “Monitor”)
on your pre-amplifier, integrated
amplifier, or receiver.
INSTALLATION
NOTE: If you are using an equalizer and/or
other external signal processing
components that are currently connected to
the Tape Monitor loop of your receiver/pre-
amp/integrated amplifier, you have two
choices:
1. Connect the deck to the Tape Monitor
loop provided on the last outboard
component; or
2. If your receiver/pre-amp/integrated
amplifier has two Tape Monitor loops,
you may connect the cassette deck to
the unused loop. (In this case, the
cassette deck will'be unaffected by the
external signal processing
components.)
DOLBY NOISE REDUCTION AND HX PRO HEADROOM EXTENSION MANUFACTURED UNDER
LICENSE FROM DOLBY LABORATORIES LICENSING CORPORATION. HX PRO ORIGINATED BY
BANG AND OLUFSEN.
“DOLBY”, THE DOUBLE-D SYMBOLDIUAND "HX PRO" ARE TRADEMARKS OF DOLBY
LABORATORIES LICENSING CORPORATION.
REMOTE
«(
c«
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: risaue O€ CHOC ELECTRIQUE
NE PAS OUVRIR