Harman Kardon DC5300 - Tape Search and Preview Functions; Music Search and Blank Skip Utility; Intro Scan Tape Preview

13
1. Press Reset at the desired return
point, setting the Tape Counter display
to 00:00.
2. Press Memory button and Memory
illuminates in the Display.
3. When you wish to return to and stop at
the Memory Rewind position on the
side of the tape facing front, press <q
(Rewind). For the side of the tape
facing rear, press }>p> (Fast Forward).
4. When you wish to begin play from the
Memory Rewind position on the side
of the tape facing front, press p>»
(Forward Play) while holding down the
<4<q (Rewind) button. For the side of
the tape facing rear, press <q
(Reverse Play) while holding down
the p>»p (Fast Forward) button.
NOTE: When the Counter is reset to
00:00 at the beginning of a cassette, the
approximate time remaining can be
determined by subtracting the counter
reading from the total tape time. Accuracy
is typically within one minute of the tape’s
actual running time.
ADVANCED OPERATIONS
Music Search
(DC5500 & DC5700 only.)
The unit can quickly locate the start of any
desired segment on a pre-recorded tape.
1. Press Music Search; SEARCH
illuminates in the display.
2. To find the beginning of the next
selection, press p>» while in Forward
Play or <4<q while in Reverse Play.
P 01 is displayed, the unit scans ahead
rapidly, and returns to normal play at
the next selection.
3. To skip ahead 2 or more selections,
press <Q<q while in Forward Play up to
15 times. The Display will show the
number of selections you wish to skip
(P-02 up to P-15), and will count down
as each selection is skipped until it
reaches P-00. Play then begins.
4. To find the beginning of the current
selection, press <{<q while in Forward
Play or p>} while in Reverse Play.
P 00 is displayed, the unit scans back
rapidly, and returns to normal play at
the next selection. Continue pressing
<4 or PP to locate the beginning of
previous selections (designated P-01,
P-02, etc.).
Blank Skip
(DC5500 & DC5700 only.)
Press the Music Search button. If the unit
senses no sound for approximately 10
seconds in Play mode, it automatically goes
into Search mode until it finds the next
track. Then it returns to Play mode.
Intro Scan
(DC5500 & DC5700 only.)
At a single touch, the unit automatically
previews a pre-recorded tape, playing the
first 15 seconds of each segment, then
rapidly advancing to the next.
1. Press Intro Scan; INTRO illuminates in
the display. The unit scans the tape at
high speed, locates the beginning of
recorded material, and plays for 15
seconds. The tape is then advanced to
the beginning of each successive
recorded segment or track and played
for 15 seconds before automatically
advancing to the next track.
2. While in Intro Scan, you may skip to the
next track or go back to the previous
track by pressing >> or <q.
3. Press p> or <q during any 15-second
play segment to go directly into play.
4. Tostop Intro Scan, press @.
NOTE: Intro Scan will automatically preview
both sides of a tape in this manner if the -
direction m@de indicator displays either
(c2>) or (C2>) when Intro Scan is selected.
If the direction mode indicator displays =,
Intro Scan is automatically turned off when
one side of the tape has been scanned.