MN662790RAS1
66 CLVS O Spindle servo phase synchronization signal output. "H" level: CLV. "L"
level: rough servo.
67 CRC O During default operation, subcode CRC check result output. "H" level: OK.
"L" level: no good.
During command execution, pulse output for external track counter.
68 DEMPH O De-emphasis detection signal output. "H" level: ON.
69 FLAG6 or O When IOSEL is "L" level, FLAG6 output, signal for resetting address of
RESY RAM for error correction de-interleave. "L" level: address reset.
When IOSEL is "H" level, RESY output, frame resynchronization signal.
"H" level: synchronized. "L" level: out of sync.
70 IOSEL I Mode selection pin
71 TEST I Test pin. Keep this at "H" level.
72 AV
DD1
I Power supply for analog circuits. (common use for left and right channel
audio outputs.)
73 OUTL O Left channel audio output.
74 AV
SS1
I Ground for analog circuits. (common use for left and right channel audio
outputs.)
75 OUTR O Right channel audio output.
76 RSEL I RF signal polarity selection pin. "H" level: bright level is "H."
"L" level: bright level is "L."
77 V
CC5V
I 5-V power supply applied to pins for 5-V input.
78 PSEL I When IOSEL is "H" level, test pin. Keep this at "L" level.
When IOSEL is "L" level, SRDATA input.
79 MSEL I When IOSEL is "H" level, frequency selection pin for SMCK pin output.
"H" level: SMCK=8.4672 MHz
When IOSEL is "L" level, LRCK input.
"H" level: left channel data.
"L" level: right channel data.
SMCK output fixed at 4.2336 MHz.
80 SSEL I When IOSEL is "H" level, SUBQ pin output mode selection pin.
"H" level: buffered subcode Q mode.
"L" level: CLDCK synchronization mode.
When IOSEL is "L" level, BCKL input.
Buffered subcode Q mode.
Pin Descriptions (continued)
Pin No. Symbol I/O Function Description
FL8380
FL8385
harman/kardon
To Next Page
Loading...
