¡ AC Power Cord
™ Coaxial Digital Output
£ Remote Control Output
¢ Remote Control Input
∞ Analog Audio Outputs
¡ AC Power Cord: Connect this plug to an AC outlet.
If the outlet is switch-controlled, make certain that the
switch is in the ON position.
™ Coaxial Digital Output: Connect this jack to the
coaxial-digital input of a digital audio/video receiver or an
external digital-to-analog converter for direct access to
the digital signals of the FL 8385. DO NOT connect this
jack to the standard audio inputs of any device.
£ Remote Control Output: Connect this jack to the
input of another compatible Harman Kardon remote
controlled device to have the remote sensor on the
FL 8385 provide signals to other products.
¢ Remote Control Input: Connect the output of a
remote infrared sensor or the remote control output of
another compatible Harman Kardon product. This will
enable the remote control system to operate even
when the front panel
Remote Sensor $ is blocked.
It will also allow use of the FL 8385 with optional,
external control systems.
∞ Analog Audio Outputs: Connect these jacks to
the analog CD audio inputs of your receiver, surround
processor or preamplifier.
NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product at
www.harmankardon.com.
To Next Page
Loading...
