Harman Kardon HK3500 - Using Preset Station Memory; Making Audio Recordings

Using the Preset Buttons
Your receiver allows you to store 16 station
settings and quickly access them, using the
8 Preset buttons along with the Shift A-B
button. The Preset stations are designated
by the letter A or B, fotlowed by a number
from 1 to 8. Any designation may be used
for any AM or FM station, in whatever
combination you choose.
To enter a station in memory:
1. Tune to the desired station.
2. Be sure Seek-Stereo setting is the one
desired”.
3. Press the Shift A-B button to display the
desired letter.
4. Press the Memory button. (“Preset” will
flash for about 8 seconds.)
5. With “Preset” flashing, press the desired
numbered Preset button.
*NOTE: When a station is set in memory,
the Seek-Stereo setting is also entered.
Subsequently, each time a station is
recalled using a Preset button, the tuner
automatically switches to the original Seek-
Stereo setting for that station.
Memory
Shift A-B
To change a preset station:
Simply enter the new station. The old
station is automatically erased.
To access a preset station:
Press the Shift A-B button to display the
correct letter. Then press the desired
numbered Preset button.
NOTE: Preset stations are stored
indefinitely while the unit is connected to a
live AC source, and for approximately 1
week when the unit is unplugged.
Making a Recording
Press the “Rec Out” button corresponding
to the component you wish to record from.
Recording may be made on tape deck 1 or
2, or both simultaneously. You may also
record from either tape deck to the other.
NOTE: By selecting different sources for
Function and Rec Out, you may listen to
one stereo component while recording from
another.
Tape 7 Tape 2
12