REAR-PANEL CONNECTIONS
AMPLIFIER
Right and Left Speaker Output Terminals: Use two-conductor
speaker wire to connect each set of terminals to the correct speaker.
Remember to observe the correct polarity (positive and negative con-
nections).
Input From Controller: Connect the included ribbon cable to this
connector and to the corresponding connector on the MAS controller.
This cable passes audio signals from the controller to the amplifier, and
it transfers AC power from the amplifier to the controller. If this cable
is ever damaged, do not use it, and contact Harman Kardon, Inc., for a
replacement.
AC Power Input: After you have made all other connections, plug the
AC power cord into this receptacle and into an unswitched wall outlet.
AC Power
Input
Right Speaker
Output
Input From
Controller
Left Speaker
Output
To Next Page
Loading...
