Harman Kardon Onyx Studio - Page 21

Harman Kardon Onyx Studio
Assembly procedure
2. ASSEMBLY INSTRUCTION 裝說明
1. 取藍牙小板 BT Antenna, 使用鑷子，撕除
藍牙小板離型紙，把藍牙小板貼入前殼對
應位置(注意：藍牙天線需壓緊)
Tears off linear of adhesive from BT Antenna
Assy and stick on the front cover by pressing as
shown in the figure.
Note: Please use the pressing fixture for this
assembly.
注意：密封圈勿折疊, 密封圈勿脫出
Attention: Do not bent the rubber ring and let it
out of the gap.
2.1 把 Front Radiator 裝在前殼對應位置(Front
Radiator 安裝位置有防呆設計)
2.2 使用螺絲起子，依次鎖付 4PCs 螺絲
(3*10.2MM)
藍牙天線貼付于兩螺柱
中間位置
密封圈折疊
密封圈脫出
2
1
3
4