Need help?Do you have a question about the Harman AVR 147 and is the answer not in the manual?
General| Channels | 5.1 |
|---|---|
| Total Harmonic Distortion | 0.07% |
| Input Sensitivity/Impedance | 200 mV / 47k ohms |
| Signal-to-Noise Ratio | 100 dB |
| HDMI Inputs | 3 |
| HDMI Outputs | 1 |
| Component Video Inputs | 2 |
| Component Video Outputs | 1 |
| Composite Video Inputs | 4 |
| Composite Video Outputs | 1 |
| Digital Audio Inputs (Optical) | 2 |
| Digital Audio Inputs (Coaxial) | 1 |
| FM Tuner Section - Frequency Range | 87.5 - 108 MHz |
| FM Tuner Section - Distortion (Mono/Stereo) | 0.2%/0.3% |
| FM Tuner Section - Selectivity (±400kHz) | 60 dB |
| AM Tuner Section - Signal-to-Noise Ratio | 45 dB |
| Video Section - Input Level/Impedance | 1Vp-p/75 Ohms |
| Video Section - Output Level/Impedance | 1Vp-p/75 Ohms |
| Audio Inputs/Outputs | 6 |
| Surround Sound Modes | Dolby Digital, DTS |
| FM Tuner Section - Usable Sensitivity (IHF) | 1.3 µV |
| FM Tuner Section - Signal-to-Noise Ratio (Mono/Stereo) | 70 dB / 70 dB |
| FM Tuner Section - Stereo Separation | 40 dB |
| AM Tuner Section - Frequency Range | 530 - 1700 kHz |
| AM Tuner Section - Distortion (1kHz, 50% Mod) | 1% |
| Video Section - Video Frequency Response | 5 Hz - 10 MHz |
| Power Requirement | 120V AC, 60Hz |
| Dimensions (H x W x D) | 6.5 x 17.3 x 14.5 in |
Warning about opening the product to avoid electric shock.
Ensure correct voltage for operation.
Use only the attached power cord.
Avoid shock hazard; no user-serviceable parts inside.
Place on a firm, level surface with ventilation.
How to connect speakers to the receiver terminals.
Connecting the subwoofer output to the subwoofer.
Connecting audio/video sources to the AVR.
HDMI connection for digital audio and video.
Connect speakers to the AVR's terminals.
Connect the subwoofer output to the subwoofer.
Connect various audio/video sources to the receiver.
Connecting HDMI-capable devices.
Connecting a second HDMI-capable device.
Connect the receiver to the video display.
Connect each component's AC power cord.
Program remote to control other devices.
Accessing the full-screen menu system.
Automatic speaker calibration and setup.
Assigning audio/video inputs to sources.
Steps to power on the receiver.
Switching between input sources.
Choosing desired surround sound modes.
Manually configure system settings.
Configure speaker size settings.
Measure speaker distances for delay.
Accessing the manual setup menu.
Detailed speaker size configuration.
Configure speaker crossover settings.
Adjust speaker delay settings.
Manually set channel output levels.
Configure system settings for ease of use.
Using the remote for various functions.
Program controls for other components.
Program sequences of commands.
Reset remote to factory defaults.
Reset receiver to factory defaults.
To Next Page
