Harman HydroFlex 60 Pellet Boiler - Page 31

31
3-90-233R24_11/13
Operation
NOTE: Stirring the starting gel into the pellets usually allows
the re to become established quicker.
CAUTION: A vapor ash could occur if too much time is
allowedtopassbeforelightingthestartinggel.
CAUTION:Caremustbetakennottogetstartinggelon
yourhands or clothing.Seriousburns could occurduring
thelightingprocess.
CAUTION:Nevertrytoapplymorestartinggeltoanalready
burningre,orarewithsmolderingpellets.
“NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR “FRESHEN UP “ A FIRE
IN THIS BOILER. KEEP ALL SUCH LIQUIDS WELL AWAY
FROM THE UNIT WHILE IN USE”.
STARTER
GEL
Fig. 15
11. Apply starting gel as shown in Fig. 15
12. Light The Starting Gel With A Match.
13. Close The Doors - Therewilllightandthecontrolwill
adjusttherateofburntotheproperlevel,accordingto
theMAXTEMPdialsetting.
Solid-fuelburningappliancesneedtobecleanedfrequently
becausesoot, creosote,and ashmay accumulate.If you
suspectachimney/ventpiperedothefollowing:
1. Calltheredepartment.
2. Removefuelfromtheburnpotusingtheburnpotscraping
tool to scrape the pellets into the ash pan.
3. Removetheashpanfromtheunitandtakeoutside.Do
notplacetheashpanonacombustiblematerial.
4. Turnoffcircuitbreakeratunit.
5. Donotusetheunituntilaqualiedpersonhasinspected
yourapplianceandventing.
Fig. 16
NOTICE: When burning the boiler in the manual
ignition mode, there must be an overheat dump
zone incorporated into the plumbing system.
Ifheatingdemandstopsduringmanualoperation,thecontrol
willtaketheunittolowburn.Ifnoheatisusedduringthis
time,thewatertemperaturewillcontinuetorise.Whenthe
aquastatsenses220°F,thefeederwillbeturnedoffand
therewillgoout.Thiswillrequireamanualre-startofthe
system.(seepage26“7Blinks”)