Quick Reference ( Auto-Light )
1. Turn Mode Selector to OFF.
2. Scrape the air holes in the burnpot.**
3. Fill the hopper with pellets.
4. Turn Feed Adjuster to “Test”.*
5. Check the Combustion Blower and Feeder Motor for operation.*
6. Turn Feed Adjuster back to the #4, or previously known setting.
7. Turn the MAX TEMP dial to the desired temperature.
8. Turn MIN TEMP dial to the desired settings.*
9. Flip the igniter switch to Auto.*
The boiler will ignite if the temperature of the boiler water is less than the
temperature set on MAX TEMP dial..
*See the section on Operation for information about Manual Lighting and
Emergency Power.
**See the section on Maintenance for more details about cleaning.
To Previous Page
Loading...