Harman JBL CRUISE - Important Safety Instructions; General Safety Precautions; FCC, IC, and RF Exposure Compliance

IMPORTANT SAFETY INSTRUCTIONS
For an products:
1. Read tl"5e Instructions.
2. Keep tl"5e instructions.
3. Heed ~ warnings.
4.
Fallow Ml lMlmctloM.
S. Do not block any wntllition openings. lnstaD this 1pp1m115 in accordance with the
lllillUfa<tlffls Instructions.
6. Do not insbll thls,pparatus near any hNt SOUlffl sud! as radiators, heat registers,
stows orother ~ (kldudlng ampllfiffl) that produce heal
7. Do not deftat the sa1'ty 1J11POW !If the polirtml or~ plug. A
polartzM plug has two blades with one wider than the other. A grounding-type
plug his twll bladfs and a lhiRI grounding p11111g. Thf wide~ orthe thin! prong
Is provided for ,our yfety. If the piovlded plug dots not fit intD ,our outtet. consult
• electridan for~ of the ob5olele outlet.
8. PlolKt the power conl from being waled on or pln<bed. partkularty at plugs.
CIJIMlliellC! ,eaplade and the point wt. they elil fnlm 1ht apparatus.
9. Use only ittiehrnents!KCISSOlles spedfied by the~
10. Use ONJ with the cat, stllld. ~ brat or table spedfied bJ
the ll)illUfadurtr or sold with the appaqtus. wtlfll a c,rt Is ustd,
ust cautlOnwben mowing theart/ijlpiratus comblnlllon ID
Mid i;lry from tip-over.
®
11 . Unplug this ippililll5 during liglltnlng storms or when unused far long periods
oftime.
12. Todsamect thlsappnus tomtheK. malnsa,mpletely, disalnnectthe power-
supply ain1 p1ug nm the"- lfflllln•
11 111eunsp1ugofthepower--supptyconlsW Rffliin leidilyopeqble.
14. Do note,q,ose billllles ID fDSslw hNt such as SIIIShilf. 1ft or the like.
15. This apparatus Is Intended ID be IISed only with the patftl' supply and/or
dYrging cable pnwid@d by the l!lilllfactlffl.
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
TttE LIGHTNING FLASH WITH AN ARROWHEAD SYMBOL, WllttlN AN
A.
EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE
PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE'WITHIN THE
PRODUCT'S ENUOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO
CONSTITUTT A RISK OF ELECTRIC SHOCK TO PERSONS.
A
THE EXCIAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS
INTENDED TO ALERT lttE USER TO THE PRESENCE OF IMPORTAMT
OPERATING AND MAINTENANCE (SERVIONG) INSTRUCTIONS IN THE
LJTERAT\JRf ACCOMPANYING THE PRODUCT.
WARNING: TO RE0UCETHE RJSK Of FIRE OR ELECTRIC SHOCK, DO NOT EXPOSETHIS
APPARATUS TO RAIN OR MOISTURE .
CAUTION FCC AND IC STATEMENT FOR USERS (USA AND
CANADA ONLY)
This device complies with part 15 of the FCC Rules. Operation Is subject to !ht following two
conditions: ( 1) This devKe may not c.use harmful 1nteifMnce, and (2) this device must
accept any Interference receried. including interferenCI! that may c.use undesired operation.
CAN KES-3(8)/NMB-3(8)
FCC SDOC SUPPLIER'S DECLARATION OF CONFORMITY
HARMAN International hmby d~m that this equipment is in compl1.1nce with the FCC
Part 1 S Subpart 8.
Tht dedaration of conformity may be consulted In the support section of our Web site,
accessible from www.jbl.com
Federal Communication Commission Interference Statement
This equ,pment has been tested and found to comply with the limits fol a Class B digital device,
pursuant to Part 15 of the FCC Rules. These bnuts ait designed to provide reasonablt protectlOn
against harmful ioterfereoce in a residential installatlOfl. This equipment general!S, uses and can
radiate radio frequency eneigy .ind. If not Installed and used in a«onlance with the in!lructions,
may cause harmful interference to radio communi<Atlons. However, thett is no guarantee that
lnteifMnce will not occur in a particular mstlll.ition. If this equipment does c.ust hallnful
Interference to radio or television reception, which can be detennlned by tum1ng the equ1pmer1t
off and on, the user is fflCOWged to try to correct !ht interfmnce by one or more of the
following measures:
Reorient or relocate the receiving antenna.
• Increase 1M ~rabon between the equipment and rectivef.
Connect the equipment Into an outlet on a circuit different from that to which the receiver 1s
connected.
Consult 1M dealer or an experienced radio/TV technid,Jn for help.
Caution: Changes or modifications not expressly approml by HARMAN could void the usel's
authority to operate 1M equipment
For Products That Transmit RF Energy:
F<C AND IC INFORMATION FOR USERS
This device complies with Part 15 of the FCC rules and Industry Canada lkense•exempt RSS standard(s).
Operation is subject to the follOWlng two conditions: (1) This deVlce may not cause harmful
interference; and (2) this device must accept .iny interference received, induding interference
that may cause undesired operation.
FCC/IC Radiation Exposure Statement
This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an
uncontJOlled environment
For WI-Fi SG device
FCCCiution:
High power radan are allocated as pnmary useo of the 5.25 to 5.35 GHz and S.65 to 5.85
GHz bands . These radar staUons c.n cause interference with and/or damage this device.
No configuration controls ai, provided for this wireless equ1~t allowing any change in
1M flequency of operations outsidt the FCC grant of authorization fol US operation
according to Part 15.407 of the FCC rules.
ICClutlon:
User should also be advised that
(i) The device for operation in the band 5150- 5250 MHz is only for indoor use to reduce
the potential for harmful interference to co-<hannel mobile satellite systems; (ii) the
maximum antenna gain permitted for devtees to 1M bands 5250 • 5350 MHz and 5470 •
5725 MHz shall comply with thte.lr p limit: and
(iii) Tht maximum antenna gain permrtted for devices In the band 5725 • 5825 MHz shall
comply with the e.1.r.p. hmlts specified for point-te>-point and non point-t1>-po4nt
operation as appropriite.
(iv) Users should also bt advised that high-power radars are alloc.lted ~ primary users
(i.e. priority users) of the bands 5250 • 5350 MHz and 5650 • 5850 MHz and that these
radars could c.use interference and/or damage to LE-lAN devKes.