12
AUDIO INPUTS
The IRX ONE has 4 inputs: 3 mono inputs, and a Bluetooth audio streaming input. All of the inputs will route to the speakers and the MIX
OU T 1/4”.
MONO MIC/LINE INPUTS
Moving from left to right there are three identical input strips comprised of: (from top to bottom) a gain control (mic/line), treble control,
bass control, and a level control. Between the CH1 & CH2 strip, there is also a phantom power enable button for channels 1 & 2.
IRX ONE_Artwork
Mixer Panel
Design: Yanyang Jia
Date: 2023-06-29
Units: mm
M 1:1
Only for QSG
IRX ONE_Artwork
Mixer Panel
Design: Yanyang Jia
Date: 2023-06-29
Units: mm
M 1:1
Only for QSG
Gain levels for each
connected input.
Microphone inputs will
be near the 3 o’clock
position, and line source
will be near 9 o’clock
Treble control adjusts the
amount of high frequencies
on each channel
Bass control adjusts the
amount of low frequencies
on each channel
Channel level controls
adjust the gain for each
channel
Combination 1/4” phone
(line) and XLR female (mic)
input connectors
1/4” phone (line) input connector
1/4” Balanced Mix Out for system
expansion to another unit
CH1 & CH2 Phantom button enables +48V phantom power on channels 1 &2 for
powering condenser microphones (see “Phantom Power Disclaimer” on page XX)
LED signal and limit indicators
Bluetooth audio pairing
Power button - press once
to power on, hold 3 sec to
power off
AFS - Automatic
feedback suppression
Music ducking - press
button, plug microphone
into desired input, and use
BT audio to allow ducking
when the microphone signal
is sensed
EQ presets - choose
based on application
Main system level
System Limiter LED
To Next Page
Loading...
