13
PHANTOM POWER DISCLAMER
When using condenser microphones, +48V phantom power is required to be present at the contacts of the microphone (XLR) connector
for the microphone to operate correctly. When phantom power is enabled, it is applied to both the CH1 and CH2 XLR inputs. Ensure that
phantom power is off when not required.
To prevent damage to the IRX ONE or external devices when using condenser microphones, always turn down all IRX ONE output controls
and ensure the +48V phantom power is off before connecting the microphone. Once the condenser microphone has been connected,
enable the +48V phantom power, then raise the output controls to the desired levels.
WARNING
Do not connect unbalanced sources to the XLR inputs when +48V phantom power is engaged. Doing so may cause damage to your
device. You should also ensure that your balanced sources are capable of handling +48V phantom power, as it can damage certain
balanced sources.
IRX ONE_Artwork
Mixer Panel
Design: Yanyang Jia
Date: 2023-06-29
Units: mm
M 1:1
Only for QSG
IRX ONE_Artwork
Mixer Panel
Design: Yanyang Jia
Date: 2023-06-29
Units: mm
M 1:1
Only for QSG
To Next Page
Loading...
